Offshore Construction

Specific services include:

Facing & Boring
• crane seats
• thruster housing faces and bores
• FPSO turntable flanges
• ring type grooves
• lens rings
• bearing housings
• lifting lugs
• langes up to 15,000mm diameter
• cable drums line bored
• CALRAM hinge bores

Milling & Drilling
• skid deck rails
• skidding pads
• location pads
• compressor/pump/motor bedplates
• module bases
• drilling/boring of pin location bores through piles
• milling of top deck stools
• drilling derrick mounting pads
• trepanning into vessels
• drilling & tapping up to M64/3 " BSW, and stud removal

Pipe Cutting & Prepping
• complete range of pipe cutting and prepping machines available to cover any possible pipe size/material
• heavy wall pipe a speciality
• weld free pipeline joint preparation (cutting, facing, grooving & swaging) for the GS Hydro connection
• fire mains cut, swaged etc
• match boring, grooving etc

Shaft Turning
• motor shaft
• gearbox shaft
• fan shaft turning from 100mm diameter upwards
• module trunnions
• pile outside diameter turning

Laser Alignment
• flatness surveys
• shaft alignment
• pump bore alignment checks

In-house Machining
• full range of off site machining services available to assist in the smooth progress of any project
• fast turnaround on general engineered components in hardox, duplex, inconnel, stainless steels and mild steel
• range of additional services e.g. pipe freezing, hot tapping and bolt tensioning can be undertaken by sub contractors on our approved vendor list