Pipe Cutting & Prepping
Turbine HP & IP loop pipes, main steam stop valve removal, make up pieces, heavy wall pipe a speciality, match boring.

Shaft Turning
Motor shaft, gearbox shaft, fan shaft turning.
Milling
Turbine half joints repaired, motor/compressor mounting pads, shaft keyway cutting.

Laser alignment
Flatness surveys, shaft alignment, pump bore alignment checks.

In House Machining

A full range of off site machining services are also available to assist in the smooth progress of any shut down. A fast turnaround on any items, including boiler spares and general engineered components in hardox, duplex, inconnel, stainless steels and mild steel is available from our workshop in Renfrew. A range of additional services e.g. Pipe Freezing or Bolt Tensioning can be undertaken by sub contractors on our approved vendor list.

This data sheet merely gives an introduction to the wealth of experience and ability available from Reekie Machining Ltd. Further details can be provided, on request, of specific projects, each with their own particular stringent demands in one or more respects. If you would like any further details please contact us.
e mail

in situ machining | on site machining | off site machining