Facing & Grinding
Weapons seats(Gambo1, stws, etc.), pipework flanges 25mm nb and upwards, stern tube faces, rudder bearing housing faces, hull pads, vessel/tank flanges, aerial mast seats,

Shaft Turning
Rudder stock shaft, motor/gearbox shaft turning, propshaft bearing diameters,….
Milling
Rudder stock keyways, motor/compressor mounting pads, shaft keyway cutting, Bow Dome Sonar Sole plate, Exocet pads, DLB seats, Phalanx seats, general weapons seats.

Laser alignment
Flatness surveys, shaft alignment, bore alignment

In House Machining
A full range of offsite machining services are also available to assist in the smooth progress of any refit. A fast turnaround on any items, including small fabrications and machined components in hardox, duplex, inconnel, stainless steels and mild steel is available from our workshop in Renfrew.

A range of additional services e.g. Pipe Freezing or Bolt Tensioning can be undertaken by sub contractors on our approved vendor list.

This data sheet merely gives an introduction to the wealth of experience and ability available from Reekie Machining Ltd. Further details can be provided, on request, of specific projects, each with their own particular stringent demands in one or more respects. If you would like any further details please contact us at any of the numbers listed above.

in situ onsite machining | off site sub contract machining